STAMPING BLOCK 19-24 MM

Disk Cutter Set, Ø 19-24 mm

• with cutting punches to stamp out round precious metal circles
• suitable for sheet thickness up to max. 1.2 mm
• 6 punches
• size: Ø 19 - 24 mm in 1 mm steps
• specially hardened tool steel
• sharp edges
• extremely close tolerances
• made for jewelers
• Made in Europe

How to use:

• Remove the punch
• Insert the sheet into the upper section and position under the desired hole diameter
• Grease the cutting edge of the matching punch with a lubricant (e.g. no. 3658 or 3658D), insert it and place it on the sheet metal
• Ensure the correct alignment of cutter stamp: Flat side down!
• If possible, punch out the plate with a strong hammer blow on the punching head

Note:
The video is only intended to illustrate how similar tools work:
How to Use a Disc Cutter - Features to Look For, Accessories, Tips