SATIN-FINISHBRUSH,YELLOW,0.2

This steel satin finish brush is used to clean and deburr, to give surfaces a satin finish, to make motives on jewellery.
Part of the polished surface has to be covered with adhesive paper and the work is done on the part that is not covered. The result of this operation is the fascinating contrast between dull and polished areas. The "IDEAL" brush forms regular grains which give a soft dull tone contrasting with the clearness of the polished surface. The effect of engravings on a dull ground is much more attractive than engravings on a polished, shiny ground. The "IDEAL" brush may replace, at little cost, the sandblasting, since its bristles reach any surfaces, hollow and flat, and hard-to-reach spots.

Wearing glasses is compulsory.

• Bristles Ø: 0.20 mm
• very fine satin finish on any surface, thin articles, e.g. dials, mounted rings, fine pendants.
• colour: yellow
• head-Ø: 34 mm
• total-Ø: 90 mm
• width: 25 mm
• rotating speed: max. 6000 rpm
• Wires are made of stainless spring steel