SATIN-FINISHBRUSH,RED,0.30MM

Order-No. 6802D

SATIN-FINISHBRUSH,RED,0.30MM
  • SATIN-FINISHBRUSH,RED,0.30MM

This steel satin finish brush is used to clean and deburr, to give surfaces a satin finish, to make motives on jewellery.
Part of the polished surface has to be covered with adhesive paper and the work is done on the part that is not covered. The result of this operation is the fascinating contrast between dull and polished areas. The "IDEAL" brush forms regular grains which give a soft dull tone contrasting with the clearness of the polished surface. The effect of engravings on a dull ground is much more attractive than engravings on a polished, shiny ground. The "IDEAL" brush may replace, at little cost, the sandblasting, since its bristles reach any surfaces, hollow and flat, and hard-to-reach spots.

Wearing glasses is compulsory.

  • Bristles Ø: 0.30 mm
    • give an average satin finish with a slight design formed by the impact points
    • This type is the most requested one for jewellery such as rings, pendants, silver jewellery with large surfaces, lighters, etc.
  • colour: red
  • head-Ø: 34 mm
  • total-Ø: 90 mm
  • width: 25 mm
  • rotating speed: max. 6000 rpm
  • Wires are made of stainless spring steel

SATIN-FINISHBRUSH,YELLOW,0.2SATIN-FINISHBRUSH,YELLOW,0.2
Order-No. 6802A
27,74 €
incl. VAT

Piece

SATIN-FINISHBRUSH,BLUE,0.45MSATIN-FINISHBRUSH,BLUE,0.45M
Order-No. 6802B
27,74 €
incl. VAT

Piece

SATIN-FINISHBRUSH,GREEN,0.60SATIN-FINISHBRUSH,GREEN,0.60
Order-No. 6802C
27,74 €
incl. VAT

Piece

SATIN-FINISHBRUSH,BLACK,0.80SATIN-FINISHBRUSH,BLACK,0.80
Order-No. 6802F
27,74 €
incl. VAT

Piece

SATIN FINISHBRUSH,RED,0.30MMSATIN FINISHBRUSH,RED,0.30MM
Order-No. 6803B
30,37 €
incl. VAT

Piece


This article is now in your shopping cart.
This article is now on your wishlist.