ID RING-CLAMPING-SET

ID Ring Holder

The GRS ID ring holder redefines how to hold rings and can be securely clamped in the micro block vice no. 5319/03-683. By screwing the clamping axle tight, the clamping sleeve is pressed into the clamping cone on both sides. This creates an even pressure and spreads the clamping sleeve evenly. This holds the ring securely on the inside. When using the standard cone, the tension can be adjusted so that the ring can be easily rotated while engraving. In contrast, the clamping cone locks the clamping sleeve so that the
Ring is held in a fixed position. This allows stones to be gripped safely. The ring holder is a good, affordable choice if you are looking for a simple, functional and high quality solution.

Scope of delivery:

• ID ring holder
• 2 sets of 10 clamping sleeves (Ø 13.5 mm, 14.5 mm, 15.5 mm, 16.5 mm, 17.5 mm, 18.5 mm, 19.5 mm, 20.5 mm, 21, 5 mm, 22.5 mm)
• 2 standard cones
• 2 cones with special teeth
• 1 clamping axis
• 1 clamping nut
• 1 hex nut
• 1 hex key

Hand Engraving Tools - Intro to the GRS ID Ring Holder (#004-735)